8 Standard DENTAL IMPRESSION ERRORS a dentist should AVOID

An excellent quality dental impression is critical because, without it, the dental lab would not be to fabricate accurate and well-fitting restorations. Ideally, dental impression errors should be noticed before the print is shipped to the lab. Otherwise, work could also be delayed if the impression is rejected. If the work goes ahead, there’s an increased risk of paying precious chair-side time adjusting it, or it’d have to be remade entirely.

Poor Tray Selection

The tray selected must capture the required information without distortion. It should be large enough to hide all the teeth without contacting the soft tissues. Once the impression is taken, the tray shouldn’t show through.

Inadequate Impression Material Mixing

When impression material is combined correctly; the colour is uniform and without streaks. It’s more common to urge streaking with hand-mixed putty materials, and hand-mixed materials should be kneaded quickly to make sure there is a consistent colour. This may make sure the catalyst and therefore, the base flow equally, avoiding issues with mixing. It’s critical to use tray material and wash from an equivalent manufacturer as these materials are chemically designed to figure together. Using different materials could increase the danger of separation of the wash material from the tray VPS when the impression is poured within the dental lab.

Surface Contamination

Surface contamination can lead to an unset layer of impression material. It’s going to flow from to core build-up material, or composites or adhesives leaving a greasy coating on the tooth preparation. To stop surface contamination, rinse the world with water or mouthwash once the rubber dam is removed and confirm it’s thoroughly dried. After using hemostatic agents, make sure the preparation is vigorously washed to get rid of any residual debris and hemostatic.

Poor Margin Detail

The margin is one of the foremost critical aspects of a dental impression. Without an accurate marginal image, problems like overhanging or open margins, or an inadequately fitting restoration are more likely. Usually, voids at the margin are due to an insufficient retraction or where fluid has accumulated, preventing the impression material from flowing around the margin.

Internal Bubbles

If moisture such as blood, water, or saliva, is confined within the impression material, it can cause bubbles within the impression. These bubbles could also be large enough to cause and increase the space to be filled. When the material is thicker, the interface between the restoration and tooth is weaker. Also, the prosthetic material might be thinner, increasing the danger of failure; this is often especially critical when using all-ceramic materials during which case a minimum thickness is significant. This problem is often solved by achieving hemostasis.

Trying to Rush the Impression

It is crucial to require some time, ensuring the small prints are correct (for example, packing the retraction cord). Make sure the cable is plugged correctly and has retracted the tissue sufficiently. If you rush, the thread might not have enough time to take a seat, and it’ll do little aside from traumatizing the world round the sulcus.

Choosing the proper Impression Material

Selecting the proper impression material is crucial for achieving an accurate and predictable impression. Usually, a kind setting time is preferable for your patient’s comfort; in any case, it’s vital to understand the working time for the fabric you’ve got chosen. The impression must be inserted within the active time. If it’s already set, it’s going not to seat fully and can not capture the specified details.

Failing to stay the Patient Still

Dental impressions can collapse if the patient moves or begins to gag. A method to assist the patient still is to talk with them; this may distract them so that they are less likely to notice any discomfort. Keep reminding the patient to breathe.

Scroll to Top

Contact Us

×